|
Who's Online
There currently are 5723 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
DISASSEMBLY INSTRUCTIONS
1. Using the unlock key that came with the unit or a similar tool, unlock the Mounting Box and remove toward the rear of the unit. 2. Remove the screw (A) located on the rear of the top cabinet and remove the Top Cabinet. 3. Remove two screws (B) located on the rear of the bottom cabinet then remove the Bottom Cabinet. 4. Remove two screws (C) (one located at the left side and one located at the right side of the Front Bracket) then remove the Hooks. 5. Remove the Front Panel and the Ring. 6. Remove two screws (D) from each side of the base then remove the Base. 7. Remove two screws (E) from the front bracket and remove two screws (F) from the rear cabinet. 8. Remove two screws (G) from the front deck bracket then remove the Front Deck Bracket. Remove two screws (H) from the rear deck bracket then remove the Deck and the Rear Deck Bracket. 9. Remove the screw (I) and three screws (J) from the Heat Sink then remove the Heat Sink and the K7377 Heat Sink. 10. Remove the screws (K) and remove the Antenna Clip. Remove the screw (L) and remove the Wire Clip. 11. Remove two screws (M) from the rear cabinet of the right side then remove the IC7805 Bracket. 12. Remove five screws (N) from the main board then remove the Main Board.
13.
Remove four screws (O) from each side of the rear cabinet then remove the Front Bracket and the Rear Cabinet.
3
|
|
|
> |
|